• Hey Guest!
    BCF is a resource offered at no cost to the Little British Car community. We do not require you to pay to play here. However, if you find BCF helpful, appreciate no pop up ads, and you want to ensure we stay online - Please support us with an "optional" low-cost (less than many car club dues) member upgrade. There are some benefits to upgrading!
    **Upgrade Now**
    (PS: Subscribers don't see this UGLY banner)
Tips
Tips

strange measurement request

Share this page

healeyboz

healeyboz

Jedi Knight
Offline
Could someone measure their 1275 dipstick for me... Okay, waiting for the jokes.... I need the measurement from where the stick rests on the plastic tube to the end that is in the oil. I would also like a measurement from the the resting point to the top of the max fill notch and the low fill notch. Does that make sense?

I need to make sure that I am using the correct dip stick.
 
Barry,
Measuring a couple close at hand I come up with an overall length of 9-1/2" from the metal "ring" to the tip. From the metal ring to the full line or notch (depending on year) it's 7-13/16". The fill line is 8-5/8" from the metal ring. Measuring With the rubber ring it's approx 5/32" less.
"dug"
 
Is a 1098 different? I've got mine on the workbench if you need specs.
 
Here ya go:

1. from where the stick rests on the plastic tube to the end that is in the oil....9-1/2"

2. from the the resting point to the top of the max fill notch....7-7/8"

3. and the low fill notch....8-11/16"

those are measurements 'metal-to-metal' since the dipstick doesn't need a rubber gasket if its a straight dipstick like mine.....if a bent dipstick, then the rubber gasket is needed.
 
I had a chance to measure the stick and I am getting the same readings. Thanks fellas!! I put the proper amount of oil in that the book says and it is reading a lot higher on the stick than it should. Always has...

I wonder if that is why she has such a bad leak from the front of the motor?
 
I just put a new timing cover gasket on my engine (again). I think the flexing of the front plate is causing it to leak, because otherwise everything seems flat and true.
 
Hap told me that the rubber seal that goes around the harmonic balancer leaks unless it is put on exactly straight--due to a wobbling affect of the rubber. I think that it is leaking from this area but have not had a chance to pull the rad to see.
 
the dipstick? I'll measure later and post
 
If John-Peter can't get to it, I'll take all the stuff off my 1500 Midget & make a measurement...I use the front of my 1500 as a storage shelf (I hate that car!)

77yellowmidget002.jpg
 
ecurie_ecosse said:
Tony, why do you "hate" this little car? Enquiring minds would like to know. :devilgrin:
Click to expand...
I just don't like that engine...unlike my MGB's with the Stromberg set-up, I can really 'feel' the difference in power between it & my '74 Midget....so, I just stack boxes of upholstery, panels, & carpet on its front fenders....& it even has a factory hardtop!
 
ecurie_ecosse said:
Had an idea that was the reason. SU's really do sing! :thumbsup:

Stuart. :cheers:
Click to expand...
Too many other cars - too many other projects.
 
I have a 1500 mg midget engine.

I am not just looking for the length of the dipstick, but the length of the dipstick tube. I am wondering if I have the right dipstick and dipstick tube since when I fill up the engine with oil, the mark on the dipstick is not at the full range (rather it is above the full range)

Need dimension of the dipstick cap opening to the end of the dipstick (Dimensions "A", see attached picture).

Need dimension of the dipstick tube from the end of the tube to the engine (Dimensions "B", see attached picture).
 

Attachments

  • 11650.jpg
    11650.jpg
    82.6 KB · Views: 141
Well, neither of those in the photos are a 948 or 1098 dipstick or dipstick tube!
 
I have a 1500 mg midget size engine, (just added that info to my posting, but in an earlier post I did mention that I have a 1500 engine).
 
Drain it, put in what the good book recommends and take a file and mark your dip stick.
 
Similar threads
Thread starter Title Forum Replies Date
J TR4/4A Strange Problem Fitting Inner Fender Triumph 18
E TR6 Strange Steering Rack Cap Triumph 3
Vargus TR2/3/3A Strange dents Triumph 19
nicko Strange Engine Noise Austin Healey 7
jlaird MGB Strange daily question. MG 10
C MGB strange?? MG 3
J TR2/3/3A such strange thread on gear shift knob Triumph 12
7 Strange A/C - radio problem Other Cars 7
S TR2/3/3A Strange part Triumph 3
steveg Strange gasket pieces Austin Healey 5
steveg Strange Oil Leak Austin Healey 7
D TR2/3/3A Strange hole! Triumph 5
SherpaPilot Strange Noise While Cornering in TR6 Racing 3
Jim_Gruber Strange noises - Bad U Joint perhaps? Spridgets 10
Michael Oritt Strange debris found in sump Austin Healey 19
F TR2/3/3A Strange Loud Noise Triumph 11
C Strange...can won't start and then magically ressurects Austin Healey 16
bighealeysource Strange problem with throttle staying open Austin Healey 6
D TR2/3/3A Strange Transmission Issue Triumph 9
Rhodyspit75 Strange windshield washers Spridgets 0
tahoe healey strange OD question. Austin Healey 9
andrea Very strange austin healey 3.9 Austin Healey 5
M Strange Healey Tach Austin Healey 9
Rut Strange occurance! Spridgets 19
aeronca65t Big Healey-strange wheels Austin Healey 12
bighealeysource Okay, here's one with a strange noise from the engine Austin Healey 7
J TR2/3/3A Strange fiberboard panel behind rear seat in TR3 Triumph 10
J TR4/4A Strange question that may involve the coil- Triumph 13
jlaird Todays strange question Spridgets 6
JPSmit What is that strange grinding sound in the distance? Spridgets 3
PAUL161 MGB Strange Reminder of a Missing Friend. MG 4
B Strange rear light Other British Cars 6
KVH Strange Sound Like Compressed Air Escaping Triumph 14
Bremer TR2/3/3A TR3A: Strange brake bleeding behaviour Triumph 4
B SU Carbs have strange vacuum fitting Triumph 17
Kleykamp TR2/3/3A Strange TR3 side curtains ??? Triumph 13
HAN8L1965 Strange event ? Spridgets 6
T strange litter Triumph 5
aeronca65t Strange and interesting MGs MG 3
PAUL161 Strange 5 Speed Conversion - Will it Work? MG 41
W Strange occurence Spridgets 5
P Strange clunking noise Triumph 20
bugedd Strange trans noise Spridgets 7
Musicman Strange Clicky/Tappy Sound Triumph 6
SilentUnicorn Strange things British Motorbikes 4
Bremer Strange, but interesting... factory blunders? Triumph 8
M another strange bugeye on ebay Spridgets 12
JAV strange noise Austin Healey 4
J Strange electric problem. Jaguar 11
racingenglishcars This is a strange one! Spridgets 9

Similar threads

Back
Top